17:28 antoine 

Deprecate a few ports

 

11:43 antoine 

Mark BROKEN: unfetchable

 

17:06 ehaupt 

Reset maintainer (3+ months of inactivity).

Discussed with:	portmgr (adamw, mat)

 

15:33 mat 

Cleanup $() variables in ports Makefiles.

Mostly replace with ${}, but sometime, replace with $$() because it is
what was intended in the first place. (I think.)

Sponsored by:	Absolight

 

16:20 amdmi3 

Convert LICENSE= "GPLxx # or later" to "GPLxx+"

Approved by:	portmgr blanket

 

00:28 amdmi3 

- Clarify LICENSE
- Add LICENSE_FILE
- Remove @dirrm* from pkg-plist

PR:		196218
Submitted by:	amdmi3
Approved by:	maintainer timeout (nemysis)

 

16:48 tijl 

Replace USES=libtool:oldver with USES=libtool or USES=libtool:keepla in
the 32 ports that still use it.  Bump PORTREVISION on their dependent
ports except the ones that depend on these:

audio/libogg
audio/libvorbis
devel/pcre
ftp/curl
graphics/jpeg
graphics/libart_lgpl
graphics/tiff
textproc/expat2
textproc/libxslt

In these cases the same trick as in the recent gettext update is used.
The ports install a symlink with the old library version.  When enough
of their dependent ports have had regular updates the remaining ones can
get a PORTREVISION bump and the links can be removed.

Also remove the devel/pcre dependency from USE_GNOME=glib20.  It causes
over 2200 packages to depend on devel/pcre while less than 200 actually
link with it.  The glib20 package still depends on devel/pcre so this
should not make a difference for ports with USE_GNOME=glib20.  Also,
libdata/pkgconfig/glib-2.0.pc lists pcre as a private library so
USE_GNOME=glib20 should not propagate it.

PR:		195724
Exp-run by:	antoine
Approved by:	portmgr (antoine)

 

20:50 gerald 

Update the default version of GCC in the Ports Collection from GCC 4.7.4
to GCC 4.8.3.

Part II, Bump PORTREVISIONs.

PR:		192025
Tested by:	antoine (-exp runs)
Approved by:	portmgr (implicit)

 

11:02 nemysis 

- Cosmetical changes

 

23:36 nemysis 

The goal of the game is to reach the highest possible score. You get a limited
number of pipes on each level and need to combine them to lead the water from
the house at the top of the screen to the storage tank at the bottom. For each
pipe water goes through, you get 20 points and if you fill the cross-pipe both
ways, you get 60 points. At end of each level, you are awarded depending on the
skill level:

  * Beginner: 100 points
  * Toolman: 100 points + number of pipes remaining
  * Master plumber: 100 points + 2 x number of pipes remaining

Some of the levels also have obstacles where you cannot place pipes. The game
is playable with joystick/joypad: just move it and press buttons when you go to
Options -> Configure controls

WWW: http://home.gna.org/vodovod/

PR:		ports/173881
Submitted by:	nemysis (self)
Approved by:	pawel (mentor)