Number of commits found: 24

Convert a few more ports to USES=tcl:tea

- Fix STRIP

- STAGE-clean
- Add LICENSE

Add NO_STAGE all over the place in preparation for the staging support (cat:
astro)

- Take maintainership (tcltk@)
- Convert to USES+=tcl
- Trim Makefile headers
- Fix run-time (tkgeomap)

- Remove lang/tcl83 and x11-toolkits/tk83 (expired)
- Remove references to Tcl/Tk 8.3 from bsd.tcl.mk
- Update ports that required 8.3+ to require 8.4+ (since 8.5 is the
  default, I don't expect this change to cause much trouble)

- Chase removal of Tcl/Tk 8.2

Reported by:	crees

Fix typos in COMMENT

- Update to 2.11.6

- Switch SourceForge ports to the new File Release System: categories starting
with A

- Change default Tcl/Tk version to 8.5
- Bump PORTVERSION of ports affected

Tested by:      pointyhat (pav)

- Update to 2.11.5
- Take maintainership

Reset infofarmer due to maintainer-timeouts and no response to email.

Hat:    portmgr

- Move from versioned tcl/tk CATEGORIES to simple tcl and tk categories

With hat:       portmgr

- Set --mandir and --infodir in CONFIGURE_ARGS if the configure script
  supports them.  This is determined by running ``configure --help'' in
  do-configure target and set the shell variable _LATE_CONFIGURE_ARGS
  which is then passed to CONFIGURE_ARGS.
- Remove --mandir and --infodir in ports' Makefile where applicable
  Few ports use REINPLACE_CMD to achieve the same effect, remove them too.
- Correct some manual pages location from PREFIX/man to MANPREFIX/man
- Define INFO_PATH where necessary
- Document that .info files are installed in a subdirectory relative to
  PREFIX/INFO_PATH and slightly change add-plist-info to use INFO_PATH and
  subdirectory detection.

PR:             ports/111470
Approved by:    portmgr
Discussed with: stas (Mk/*), gerald (info related stuffs)
Tested by:      pointyhat exp run

- Update tcl/tkgeomap to 2.11.4

- Update to 2.11.3

- Update to 2.11.2

PR:             ports/112349, ports/112350
Submitted by:   mm

- Convert existing ports to a new bsd.tcl.mk order

PR:             ports/109097
Submitted by:   Martin Matuska <martin@matuska.org>
Tested on:      pointyhat exp-run

- Update to 2.11.1
- After spending 4 hours on a trivial update, officially
  state that it was a broken down extension architecture
  that buried Tcl/Tk for good

- Respect X11BASE
- Add some forgotten changes

Reported by:    pointyhat via kris

- Update tcl/tkgeomap to 2.10.1
- Install/use unversioned libs

- LIB_DEPEND on Tcl/Tk

Reported by:    pointyhat via kris

Add ports astro/tclgeomap and astro/tkgeomap:

Tkgeomap is an open source set of extensions to the Tcl/Tk scripting
language. It adds commands that read, manipulate, and display geographic
data.

It provides four packages:
* tclgeomap - library written in C adds commands for basic geography
  calculations and data access.
* tclgeomap_procs - library written in Tcl adds procedures that
  supplement tclgeomap.
* tkgeomap - library written in C that adds the ability to draw maps
* tkgeomap_procs - library written in Tcl adds procedures that
  supplement tkgeomap.

WWW: http://www.tkgeomap.org/

Number of commits found: 24

16 vulnerabilities affecting 123 ports have been reported in the past 14 days

^* - modified, not new

All vulnerabilities

Last updated:
2019-06-22 13:48:42