Number of commits found: 19

Install texinfo files (GNU info) into ${PREFIX}/share/info

After a discussion on the mailing list on moving manpages to
${PREFIX}/share/man for consistency with base where it is
installed in usr/share/man, it appeared the same should happen
to GNU info files which were installed under share in base and
not in ports.

Now texinfo is not in base on any of the supported version of FreeBSD
it is possible to proceed to this move and it is easier to do than
the manpage change.

Other benefit than consistency are less patching: all build tools but
cmake are expecting info files to be under share/info and cmake (patched here)
was having an exception for BSD so the patch makes FreeBSD case less
specific for them

Bump revision of all impacted ports

PR:		232907
exp-run by:	antoine
Differential Revision:	https://reviews.freebsd.org/D17816

devel/guile-lib: Update to 0.2.6.1

While here, assign maintainer

PR:		230742
Submitted by:	Nathan <ndowens@yahoo.com>

For ports that are marked BROKEN on armv6, and also fail to build on
armv7, mark them so.

This is part two of a multipart commit to bring armv7 ports to parity
with armv6.

Approved by:	portmgr (tier-2 blanket)
Obtained from:	lonesome.com -exp run

Mark some ports failing on armv6, for errors classified as "???".

While here, pet portlint.

Approved by:	portmgr (tier-2 blanket)

Unmark broken on powerpc64

These ports built successfully

many ports: mark broken on powerpc64

Remove ${PORTSDIR}/ from dependencies, categories d, e, f, and g.

With hat:	portmgr
Sponsored by:	Absolight

- Stage support

Add NO_STAGE all over the place in preparation for the staging support (cat:
devel part 2)

- Update to 0.2.2
- Trim header

PR:		176570
Submitted by:	ports fury

Update to 0.2.1

PR:             ports/159432
Submitted by:   KATO Tsuguru <tkato432@yahoo.com>

- Chase guile shared lib bump
- Add an entry to UPDATING

Reset ijliao@FreeBSD.org due to maintainer-timeouts and long absence.
We hope to see ijliao back again sometime.

Hat:            portmgr

- Chase lang/guile shlib bump

- Chase lang/guile share library version bump (.18 -> .19)
- Bump PORTREVISION

PR:             ports/125435

Bump portrevision due to upgrade of devel/gettext.

The affected ports are the ones with gettext as a run-dependency
according to ports/INDEX-7 (5007 of them) and the ones with USE_GETTEXT
in Makefile (29 of them).

PR:             ports/124340
Submitted by:   edwin@
Approved by:    portmgr (pav)

upgrade to 0.1.6

- Set --mandir and --infodir in CONFIGURE_ARGS if the configure script
  supports them.  This is determined by running ``configure --help'' in
  do-configure target and set the shell variable _LATE_CONFIGURE_ARGS
  which is then passed to CONFIGURE_ARGS.
- Remove --mandir and --infodir in ports' Makefile where applicable
  Few ports use REINPLACE_CMD to achieve the same effect, remove them too.
- Correct some manual pages location from PREFIX/man to MANPREFIX/man
- Define INFO_PATH where necessary
- Document that .info files are installed in a subdirectory relative to
  PREFIX/INFO_PATH and slightly change add-plist-info to use INFO_PATH and
  subdirectory detection.

PR:             ports/111470
Approved by:    portmgr
Discussed with: stas (Mk/*), gerald (info related stuffs)
Tested by:      pointyhat exp run

add guile-lib 0.1.3
A down-scaled, limited-scope CPAN for Guile

Number of commits found: 19

14 vulnerabilities affecting 141 ports have been reported in the past 14 days

^* - modified, not new

All vulnerabilities

Last updated:
2018-11-20 15:43:29