Essentially, this module is a very optimized version of Clone::More.
By taking advantage of one of Clone::More's 'OPTIMIZATION_HACKS' as
well as removing all the Pure Perl from the More.pm, I was able to
gain a lot of speed out of the module. Essentially, though, the core
of the module is exactly as that of Clone::More.
You will see that by using Benchmark::cmpthese, I ran a simple
comparison between Storable::dclone, Clone::More::clone, and
Clone::Fast::clone. You will (should) begin to see the reason why I
loaded this module along side of Clone::More.
Rate Storable Clone::More Clone::Fast
Storable 7552/s -- -39% -59%
Clone::More 12400/s 64% -- -33%
Clone::Fast 18442/s 144% 49% --
For more information relative to the DESCRIPTION of this module, I
recommend peeking into the POD written for Clone::More (I took more
time with it ;) )
Remove WWW entries moved into port Makefiles
Commit b7f05445c00f has added WWW entries to port Makefiles based on
WWW: lines in pkg-descr files.
This commit removes the WWW: lines of moved-over URLs from these
pkg-descr files.
Approved by: portmgr (tcberner)
Add WWW entries to port Makefiles
It has been common practice to have one or more URLs at the end of the
ports' pkg-descr files, one per line and prefixed with "WWW:". These
URLs should point at a project website or other relevant resources.
Access to these URLs required processing of the pkg-descr files, and
they have often become stale over time. If more than one such URL was
present in a pkg-descr file, only the first one was tarnsfered into
the port INDEX, but for many ports only the last line did contain the
port specific URL to further information.
There have been several proposals to make a project URL available as
a macro in the ports' Makefiles, over time.
(Only the first 15 lines of the commit message are shown above )
devel: remove 'Created by' lines
A big Thank You to the original contributors of these ports:
* "Waitman Gobble" <uzimac@da3m0n8t3r.com>
* <jkoshy@FreeBSD.org>
* Aaron Dalton <aaron@FreeBSD.org>
* Aaron Dalton <aaron@daltons.ca>
* Aaron H. K. Diep <ahkdiep@gmail.com>
* Aaron Hurt <ahurt@anbcs.com>
* Abel Chow <abel_chow@yahoo.com>
* Adam McLaurin
* Adam Saponara <as@php.net>
* Adam Weinberger <adamw@FreeBSD.org>
* Ade Lovett <ade@FreeBSD.org>
(Only the first 15 lines of the commit message are shown above )
Change the way Perl modules are installed, update the default Perl to 5.18.
Before, we had:
site_perl : lib/perl5/site_perl/5.18
site_perl/perl_arch : lib/perl5/site_perl/5.18/mach
perl_man3 : lib/perl5/5.18/man/man3
Now we have:
site_perl : lib/perl5/site_perl
site_arch : lib/perl5/site_perl/mach/5.18
perl_man3 : lib/perl5/site_perl/man/man3
Modules without any .so will be installed at the same place regardless of the
(Only the first 15 lines of the commit message are shown above )
Remove all the bootstrap files (.bs) from the plists.
Starting with perl 5.20, they're not installed any more if empty,
and on FreeBSD, they're (always ?) empty.
PR: 190681
Submitted by: mat
Exp-Run by: antoine
Sponsored by: Absolight
