Current status

Number of commits found XX: 6

Convert a bunch of USE_BZIP2 to USES=tar:bzip2

Approved by:	portmgr (not really, but touches unstaged ports)

- Support STAGEDIR
- Switch to USES=gmake
- Remove leading indefinite article from COMMENT

Submitted by:	zont@ (maintainer via email)

- Remove default DISTNAME

PR:		ports/165609
Submitted by:	pgollucci (March 2012)
With hat:	portmgr

Add NO_STAGE all over the place in preparation for the staging support (cat:
sysutils)

- Update maintainer email address.

Submitted by:	maintainer via irc

nvramtool is a utility for reading/writing coreboot parameters and
displaying information from the coreboot table.  It is intended for x86-based
systems (both 32-bit and 64-bit) that use coreboot.

The coreboot table resides in low physical memory, and may be accessed
through the /dev/mem interface.  It is created at boot time by coreboot, and
contains various system information such as the type of mainboard in use.  It
specifies locations in the CMOS (nonvolatile RAM) where the coreboot
parameters are stored.

For information about coreboot, see http://www.coreboot.org/.

WWW: http://www.coreboot.org/Nvramtool

PR:             ports/155583
Submitted by:   Andrey Zonov <andrey at zonov.org>

Number of commits found XX: 6

13 vulnerabilities affecting 98 ports have been reported in the past 14 days

^* - modified, not new

All vulnerabilities

Last updated:
2021-02-27 01:52:12